Cadillac CTS/ELR Cup Holder Inserts Installation
This page shows you how to install the Jet Fuel Garage Cup Holder Inserts in your CTS or ELR. For more details, check out the video installation HERE.
1. Remove any left over cup holder bubbles that you wish to replace with these caps. I suggest a combination of your hands, a 90° pick, and needle nose pliers. The lowest part of the bubble tends to be attached the hardest.
​​​
2. Install the rubber replacement caps with the smooth side out.
Install like a grommet. There is a grooved edge that fits along the edge of the holes.
Align the oval shape of the cap with the hole then slowly and carefully apply pressure to work the edges of the seat around the hole. If you press too hard you may accidentally push the cap into the hole and lose it!
​​
​3. To minimize loss of caps, use an unfolded paper clip with a hooked end or 90° pick inserted into the center hole to maintain control of the cap in case it falls in. After the first couple you should be skilled at installing the others ion seconds. The rear most hole seems to fit a bit tighter.
​​
​Note: Although the caps are designed with tight tolerances, enough force by curious little fingers will push them through. However, when used normally, it is very unlikely these caps will ever displace without force.
